Settings; Changing Fan Settings; Requesting Temporary; Occupancy - Trane BCHE Installation, Operation And Maintenance Manual

Changing Heating/Cooling Settings
(does not apply to all systems)
Some systems allow you
to select both heating and
cooling room temperature
settings. If your system
has this option, this
symbol appears when
you adjust the
temperature setting.
When you adjust the
cooling setting, the top
arrow and snowflake
flash.
When you adjust the
heating setting, the
bottom arrow and flame
flash.

Changing Fan Settings

Indicates that the fan
will operate as
Fan Menu
needed to reach the
selected
temperature.
Indicates that the fan
setting is On.
The number of
arrows indicates fan
speed (3: high, 2:
medium, 1: low).
The example shown
indicates a fan on
high speed. Not all
systems offer all
three speeds.
Indicates that the fan
setting is Off.

Testing Battery Status

Indicates full battery
power
Press the Test button to display the battery status symbols.
Use only UL-listed non-rechargeable 1.5 V lithium AA
batteries (Trane p/n X13770035010 or equivalent).
BCX-SVX002A-EN
1. Press up or down arrow
to select the heating/
cooling setting.
2. If in cooling mode,
press left arrow to
change to heating
mode. If in heating
mode, press right arrow
to change to cooling
mode.
3. Press up or down arrow
to select the heating/
cooling setting.
4. To confirm, press
center button or wait 5
seconds. The home
screen will appear.
1. From the home screen,
activate the fan setting
menu by pressing and
then down arrow.
2. Press left or right arrow
to choose the desired
fan setting.
3. When the symbol for
the desired setting
appears, confirm your
choice by pressing
center button (the home
screen will appear).
Indicates 50 percent of
battery life left.
Requesting Temporary Occupancy
Select to request

occupancy

Select to cancel
occupancy

Error Codes

Indicates an error
code

Lock Symbol

Indicates that a
setting is locked

Testing Signal Strength

Indicates Indicates
excellent satisfactory
signal signal
strength strength
Press the Test button to display the signal strength symbols.
Indicates 25 percent of
battery life left. Replace
batteries. Flashing
symbol indicates that
approximately 14 days of
operation remain.
Installation - Controls
• If you need heating or
cooling after normal
business hours, you can
"request" temporary
occupancy by pressing
or right arrow and
holding it for 2 seconds.
The occupied symbol
remains on the screen
and the unoccupied
symbol disappears. After
30 seconds, the
unoccupied symbol will
re-appear.
• To cancel temporary
occupancy, press left
arrow and hold for 2
seconds. The
unoccupied symbol will
remain on the screen
and the occupied symbol
will disappear. After
30 seconds, the
occupied symbol will re-
appear.
If an error code (E0–E7) is
displayed, technical
assistance may be required.
The lock symbol appears if
you try to adjust a setting
that cannot be changed.
Indicates
poor signal
strength
81