Controls Interface; Connecting The Operator Display; Setting Up The Operator Display; Calibrating The Operator Display - Trane Climate Changer M Series Installation Operation & Maintenance

Controls Interface

The portable operator display is used for temporary connection to and operation of Tracer MP580/
581 and AH540/541 controllers. With the portable operator display, you can monitor data, change
setpoints, monitor alarms, and override points. The portable operator display includes a 10 ft (3 m)
cable with connector that is stored in the storage compartment of the carrying bag. The cable
cannot be disconnected from the operator display. Keep this document with the portable operator
display for access to calibration and cleaning instructions.
Note: The portable operator display is not used for timeclock scheduling. To provide scheduling

Connecting the operator display

To connect the portable operator display:
1. Open the controller enclosure door.
2. Attach the operator-display cable to the operator-display connector on the controller circuit

Setting up the operator display

NOTICE
Equipment Damage!
To clean the operator display, use a cloth dampened with commercial liquid glass cleaner.
Spraying water or cleansers directly on the screen may result in equipment damage.
This section shows how to calibrate the operator display touch screen and how to adjust the
brightness and contrast. To set up the operator display screens and security, see the Tracer MP580/
581 Programmable Controller Programming guide (CNT-SVP01B-EN).

Calibrating the operator display

NOTICE
Equipment Damage!
Do not allow the operator display to come in contact with sharp objects. This may result in
equipment damage.
To calibrate the operator display:
1. On the home screen, press Setup. The Setup menu appears.
2. Page down to view the next screen.
3. Press Calibrate Touch Screen. A calibration screen appears.
4. Touch the target using a small, pliable, blunt object, such as a pencil eraser or your finger. Hold
5. Again, touch the target with the object. Hold until the beeping stops. The Advanced Selection
6. Press Home. The home screen appears.
CLCH-SVX03C-EN
you must use a Tracer Summit system.
board. The operator display receives power from the controller and turns on automatically
when it is connected to the controller.
until the beeping stops. A second calibration screen appears.
screen appears.
69