Program Presetting (Defaultprogram) Submenu; Setting The Stitch Length (Stitchlength) Parameter - DURKOPP ADLER 878-M PREMIUM Service Instructions Manual

Programming

17.4 Program presetting (DefaultProgram) submenu

Customer-specific settings can be made here, which are automatically
used as preset values for the first seam section during the creation of a
new program. Select the values so that they can be retained for as many
programs as possible.
The menu is divided into the following submenus:
Parameter
Stitch Length
Foot Press.
Thr.Tens.
FullnessType
Fullness
Start Tack
End Tack
Thread Trim
DailyPieces

17.4.1 Setting the Stitch length (StitchLength) parameter

The stitch length that should be set as standard when creating a new
program.
To set the stitch length parameter:
1. Select the StitchLength parameter
2. Press the OK button to confirm the selection.
3. Enter the desired value (00.0 – 7.0 mm) based on the maximum stitch
4. Press the OK button to confirm the value.
Service Instructions 878-M PREMIUM - 03.0 - 10/2019
Explanation
Stitch length
Foot pressure
Needle thread tension
Fullness type
Fullness degrees
Start bartack
End bartack
Thread Trim
Daily piece counter
NOTICE
Property damage may occur!
The machine and the sewing equipment may be damaged.
ALWAYS adjust the stitch length to the selected sewing equipment.
length T3010
Reference
 p. 67
 p. 68
 p. 68
 p. 68
 p. 69
 p. 69
 p. 69
 p. 69
 p. 70
67