Starting Position Of The Moving Knife - DURKOPP ADLER 878-M PREMIUM Service Instructions Manual

14.2 Starting position of the moving knife

Proper setting
If the sensing roller (1) touches the highest point of the cutoff curve (3), the
edge of the moving knife (5) should cross the blade of the fixed knife (4)
by 0.5 to 1 mm.
Fig. 44: Starting position of the moving knife
(1) - Roller
(2) - Ring
(3) - Cutoff curve
1. Tilt the machine head ( p. 15).
2. Check whether the cutoff curve (3) is pushed as far to the right (2).
3. Turn the cutoff curve (3) as prescribed.
4. Loosen the screw (6).
5. Turn the fixed knife (4) as prescribed.
6. Tighten the screw (6).
54
① ② ③
Service Instructions 878-M PREMIUM - 03.0 - 10/2019
⑤
④
⑥
(4) - Fixed knife
(5) - Moving knife
(6) - Screw
Thread trim