Table of Contents
Advertisement
Needle guides in 2-needle machines
9
Proper setting
1. The guides should touch the sewing material but should not apply pres-
2. In the sewing direction and on the sides, the guides should fit the needle
Fig. 21: Needle guides in 2-needle machines
(1) - Screw
(2) - Front guide
(3) - Rear guide
(4) - Screw
1. Place two layers of material approximately 1.5 mm thick under the foot
2. Loosen the screws (1) and move the holder (2) with the guide (3) vertically
3. Adjust the guides as prescribed in the instruction 2: Adjust the rear
4. Firmly tighten all fixing screws.
Service Instructions 878-M PREMIUM - 03.0 - 10/2019
Needle guides in 2-needle machines
sure on it.
hole edges.
①
②
and set a medium pressure for the foot onto the material.
until it rests on the leather. Tighten the screws (1) slightly. Loosen the
screw (4) and do the same operation with the guide (5). Remove the
leather.
guide (3) in the sewing direction using the screw (6), using the holder (2)
for side adjustment. Adjust the front guide in the sewing direction and
on the sides using the screw (7).
⑦
⑥
⑤
④
③
④
(5) - Holder
(6) - Screws
(7) - Screw
33
Advertisement
Table of Contents
