Flex I/O Card Port Module Srx-Ioc-16Ge-Tx Specifications - Juniper SRX5400 Manual

Flex I/O Card Port Module SRX-IOC-16GE-TX Specifications

You use port modules and Flex I/O Cards (Flex IOCs) to add different combinations of small form-factor
pluggable transceiver (SFP), 10-gigabit SFP transceiver (XFP), and copper ports to your services gateway
to suit the specific needs of your network. The SRX-IOC-16GE-TX port module
installs into a Flex IOC to add sixteen 10/100/1000 Ethernet RJ-45 copper ports.
Figure 15: Flex IOC Port Module SRX-IOC-16GE-TX
Description
Software release
Cables and connectors
Controls
Supported Slots
Weight
LEDs
Port module with sixteen 10/100/1000 Ethernet RJ45 ports
Maximum throughput: 10 Gbps
Oversubscription ratio: 1.6:1
Maximum configurable MTU: 9192 bytes
Junos OS Release 9.5R1 and later
Sixteen RJ-45 1-Gbps ports
ONLINE Button–The ONLINE button on the port module front panel toggles the port
module online and offline.
Either slot in SRX5K-FPC-IOC Flex IOC
Approximately 1.6 lb (0.7 kg)
OK/FAIL LED, one bicolor:
Steady green–The port module is operating normally.
Red–The port module has failed and is not operating normally.
Off–The port module is powered down.
LINK LED, single color, one per port:
Steady green–The link is active.
Off–No link.
TX/RX LED, single color, one per port:
Blinking green–The port is receiving or transmitting data.
Off–No activity.
(Figure 15 on page 33)
33