Juniper SRX5400 Manual page 87

Extractor clips—Used for inserting and extracting the Routing Engine.
Captive screws—Secures the Routing Engine in place.
The Routing Engine boots from the storage media in this order: the USB device (if present), then the internal
flash disk, then the hard disk, then the LAN.
NOTE: For specific information about Routing Engine components (for example, the amount of
DRAM), issue the show chassis routing-engine command.
Description
Software release
Cables and connectors
Controls
Supported Slots
Power Requirement
Weight
Routing Engine for SRX5400, SRX5600, and SRX5800 Services Gateways
Junos OS Release 9.2 and later
Junos OS Release 10.0 and later required to install a second Routing Engine
AUX—Connects the Routing Engine to a laptop, a modem, or another auxiliary device through
a cable with an RJ-45 connector.
CONSOLE—Connects the Routing Engine to a system console through a cable with an RJ-45
connector.
ETHERNET—Connects the Routing Engine through an Ethernet connection to a management
LAN (or any other device that plugs into an Ethernet connection) for out-of-band management.
RESET button—Reboots the Routing Engine when pressed
ONLINE/OFFLINE Button—Not supported in the current release
Front panel slot in an SCB installed in:
SRX5400: Bottom slot 0
SRX5600: Bottom slots 0 or 1
SRX5800: Center slots 0 or 1
NOTE: The services gateway host subsystem Routing Engine must be installed in the SCB
in slot 0. A Routing Engine installed in an SCB in slot 1 only enables dual control links in
chassis cluster configurations.
90 W
Approximately 2.4 lb (1.1 kg)
79