Midmounting The Junos Space Appliance In A Two-Post Rack - Juniper Junos Space JA2500 Hardware Manual

JA2500 Junos Space Appliance Hardware Guide
Related
Documentation

Midmounting the Junos Space Appliance in a Two-Post Rack

34
Tighten the side-rail screws.
3.
Insert the two small screws in the recessed holes on the front rails and tighten.
4.
Slide the rear-mount rail brackets into the backs of the front rails on either side of the
5.
chassis and align with your rear equipment rack posts. Secure the rear-mount rail
brackets to your equipment rack with two rack mount screws each, as shown in
Figure 7 on page 34.
Figure 7: Front-and-Rear Mounting Recessed in a Rack
Insert locking screws on the sides of the rear-mount brackets to secure the front and
6.
rear mounting brackets in place.
Verify that the mounting screws on one side of the rack are aligned with the mounting
7.
screws on the opposite side and that the appliance is level.
The recessed position allows network and console cables to be routed through the sides
of the equipment rack and through the holes of the recessed front rails on either side of
the unit. This enables easy cable routing on the racks with limited cable management.
Front-and-Rear Mounting the JA2500 Junos Space Appliance Flush to a Rack on
page 32
Junos Space Appliance Rack Requirements on page 25
Midmounting the Junos Space Appliance in a Two-Post Rack on page 34
Tools and Parts Required to Install the Junos Space Appliance on page 26
This topic applies to the following Junos Space Appliances: JA1500 and JA2500.
This option is suitable for a two-post equipment rack. It allows the appliance to be
mounted so that there is even clearance on the front and rear of the rack.
To mount the appliance in a two-post rack, do the following:
Remove the two front-mount rails from either side of the chassis.
1.
Insert one midmount bracket to the center on either side of the chassis.
2.
Copyright © 2014, Juniper Networks, Inc.