Removing The Fan; Installing The Fan - Juniper Junos Space JA2500 Hardware Manual

Removing the Fan

Installing the Fan

Copyright © 2014, Juniper Networks, Inc.
To remove a fan from a Junos Space appliance, do the following:
(Optional) Place the antistatic bag or antistatic mat on a flat, stable surface.
1.
(Optional) Attach an ESD grounding strap to your bare wrist, and connect the strap
2.
to an external ESD point.
Press the latch at the side of the fan, as shown
3.
fan.
Figure 22: Removing a Fan
Pull the fan module out of the chassis.
4.
(Optional) Place the fan module in the antistatic bag or on the antistatic mat placed
5.
on a flat, stable surface.
To install a fan in a Junos Space appliance, do the following:
(Optional) Attach an electrostatic discharge (ESD) grounding strap to your bare wrist,
1.
and connect the strap to an external ESD point.
Remove the replacement fan module from its antistatic bag.
2.
Insert the replacement fan into the slot for the fan module, as shown in
3.
Figure 23 on page 100, until the latch locks and you hear a clicking sound.
Chapter 11: Replacing Hardware Components
Figure 22 on page 99 to release the
99