Copying Separately-Set Originals (Job Build) - Canon iR6020i Copying Manual

Copying Separately-Set Originals
This mode enables you to scan originals that are too many to be set at once, by dividing them into
multiple batches. You can use both the feeder and the platen glass for scanning. The originals are
copied as one document, after all the batches have been scanned.
Originals
IMPORTANT
•
The only copy settings that can be changed while scanning originals in the Job Build mode are numbers
of copies, 2-Sided Original, original type, and copy exposure. All other settings must be set beforehand,
according to the type of original or the desired Copy mode.
•
If you place the originals in the feeder, remove each original from the original output area when scanning
is complete.
NOTE
•
If you place different-sized originals in the feeder, set the Different Size Originals mode.
•
If you want to copy one-sided and two-sided originals as two-sided, and if the first sheet is one-sided,
set the 1 2-Sided mode before scanning. If the first sheet is two-sided, set the 2 2-Sided mode before
scanning. To scan the next batch of originals, set or cancel the 2-Sided Original mode according to the
type of original.
•
It is useful to store originals in an inbox and print them with the Merge Documents mode when you
cannot prepare originals at one time, or when you want to set different settings for each original.
(See "Chapter 4 Using/Arranging Documents Stored in an Inbox" in the Mail Box Guide.)
Copies

Copying Separately-Set Originals (Job Build)

(Job Build)
2-49
2