How To Show The Navpilot Control Box In The Data Area; How To Make An Automated Turn With The Navpilot; How To Change The Navpilot Settings - Furuno NAVnet TZtouch2 Operator's Manual

2. PLOTTER
2.13.2

How to show the NAVpilot control box in the data area

1. Tap [DATA] or [ROUTE] on the data area to select where to show the NAVpilot
control box.
2. Tap a data box or an unoccupied area to select where to show the NAVpilot con-
trol box. A pop-up menu appears.
3. Tap [NAVpilot] to show the NAVpilot control box in the area selected.
Note: The example figure below shows the NAVpilot-300 series. The turn/menu but-
ton is not shown on the NAVpilot-700 series, however all other indications are the
same.
AUTO mode AUTO mode
Course adjustment buttons.
(Port=Red, STBD=Green)
Tap the single arrow for fine adjustments;
Tap the double arrow for coards adjustments.
2.13.3

How to make an automated turn with the NAVpilot

1. Tap the [Turn/menu button] to show the NAVpilot menu.
2. Tap the desired turn type. For details regarding the turn types, see the NAVpilot
operator's manual.
2.13.4

How to change the NAVpilot settings

1. Tap the [Turn/menu button] to show the NAVpilot menu.
2. Tap [NAVpilot Settings] to show the NAVpilot settings menu.
3. Change the settings as required. For details, see the NAVpilot operator's manual.
Note: You can also access the NAVpilot settings from [Home][Settings][Initial
Setup], then tap the indication for your NAVpilot in the [NETWORK SENSOR SETUP]
section.
2-26
Stand-by mode Stand-by mode
AUTO/NAV
mode buttons.
NAV mode NAV mode
Turn/Menu button.
Appears in all modes for
NAVpilot-300 series only.