Microsd Cards/Sd Cards - Furuno NAVnet TZtouch2 Operator's Manual

1.11

MicroSD Cards/SD Cards

This equipment uses two types of microSD cards/SD cards, chart cards and data
cards. The chart cards contain charts and the data cards store plotter-related data
such as tracks, routes, points and generic data such as menu settings. (The microSD
card drive on the TZTL12F/TZTL15F display is for chart cards only. Use the SD card
unit for data cards and chart cards.) Set and remove the card as shown below. Secure
Digital Extended Capacity (SDXC) cards can also be used.
Note: SD cards are available for use with the TZT2BB only.
How to insert a microSD card/SD card
Before inserting a chart card in the multi function display, turn off the power.
Unfasten two
screws.
Chart card drive (multi function display)
Peel the card slot
cover from the top end
to show the card slots.
Note: The TZT2BB does not recognize cards that are locked. Before inserting a card, check the
tab on the side of the card to be sure that the card is unlocked.
How to format a microSD card/SD card
You do not normally need to format a data microSD card/SD card. If the card becomes
unreadable, format the card with a formatting program that is compatible with the
specifications of the card.
How to remove a microSD card/SD card
1) Open the card drive cover.
2) Push the card to release the card from the card drive.
3) Remove the card with your fingers then close the lid (cover).
For TZTL12F/TZTL15F For TZTL12F/TZTL15F
Push card into slot
and close cover.
For TZT2BB For TZT2BB
Protective
cover
For chart cards
Note: After installing the chart card, be sure to replace the protective cover.
For tracks, routes, points
and settings data cards
1. SYSTEM INTRODUCTION
Push card
Open cover.
into a slot
and close
cover.
SD card unit (SDU-001)
Remove the
protective cover
Install the data card in the right slot.
Install the chart
card in the left slot.
1-25