Furuno NAVnet TZtouch2 Operator's Manual page 272

12. INSTRUMENT-RELATED DISPLAYS
Full screen
The default full screens are [Full 1], [Full 2], [Single Engine], [Twin Engines], [Triple
Engines], [Quad Engines] and [Historical Graphs]. (The availability of the displays de-
pends on your system configuration.) You can switch between the displays by swiping
downward at the bottom of the display, or tapping the screen to display the pop-up
menu shown below and tapping the display of your choice.
12.1.4 How to edit the instrument display
The instrument displays are fully customizable. You can edit the displays as follows:
• Remove an indication from a display
• Add an indication to a display
• Rearrange the indications in a display
• Rename a display
• Delete a display
• Remove a display
• Add a custom display
Note: To restore the default instrument displays, go to the Home screen, then tap
[Settings] - [Initial Setup] - [Graphic Instruments Setup] - [Reset Instrument Pages]. All
default displays are restored and any custom displays are deleted.
How to prepare for editing
To start the editing process, tap anywhere on an instrument display to show the pop-
up menu, then tap [Edit Page] on the menu. A blue line circumscribes each indication
in the display, as shown in the figure below. Edit the display referring to the procedures
in the coming sections. To save your changes, tap anywhere on the instrument display
to show the pop-up menu, then tap [End Edit] on the menu.
12-11