How To Show Or Hide The Scale Box - Furuno NAVnet TZtouch2 Operator's Manual

From the layers menu
1. Open the layers menu.
2. At [Picture Advance], tap the required speed.
The default speed is [1/1] (normal speed), the fastest speed is [4/1] (four times normal
speed) and the slowest speed is [1/16] (sixteen times slower than normal speed). Se-
lect [Stop] to stop the picture advance for closer examination and screenshots/photos.
8.3.6

How to show or hide the scale box

The scale box, shown at the bottom left corner on the display, shows depth and TX
frequency. You can show the box as follows.
1. Tap the multi-sounder display to show the pop-up menu.
2. Select [Scale Box] to show the scale box.
8.3.7 Availability of points and event marks registration, and go to a
point
For operation, see chapter 4.
The table below shows function availability according to latitude/longitude, heading
data presence or absence. If there is no latitude/longitude data, none of the functions
below are available.
For a multi function display, input PGN data. The PGN data available is as shown be-
low.
Latitude/longitude data
• 129025 Position, Rapid Update
• 129029 GNNS Position Data
Heading data
• 127250 Vessel Heading
• 130577 Direction Data
Item
Point registration
Go to point
Event mark registration
Item
Point registration
Go to point
Event mark registration
Latitude/Longitude / Heading data: YES
Starboard
Yes
Yes
Yes
Latitude/Longitude: YES, Heading data: NO
Starboard
No
No
Yes
8. MULTI BEAM SONAR DFF-3D
Downward
Yes
Yes
Yes
Downward
Yes
Yes
Yes
Port
Yes
Yes
Yes
Port
No
No
Yes
8-7