Furuno NAVnet TZtouch2 Operator's Manual page 250
Multi function display
Hide thumbs
Also See for NAVnet TZtouch2:
- Setup procedures (19 pages) ,
- Operator's manual (17 pages) ,
- Software update procedure (12 pages)
Table of Contents
Advertisement
10. CAMERA/VIDEO/EXTERNAL EQUIPMENT
Axis Quad Server digital signal
A maximum of two Axis Quad Servers can be connected. Each server can be set in-
dividually with the menus [AXIS QUAD SERVER] and [SECOND AXIS QUAD SERV-
ER], respectively.
Server: Turn this item on to receive the signal from the Axis Quad Server.
IP Server: Enter the IP address of the server, using the software keyboard. Tap [] to
finish.
Quad Mode: Turn this item on to feed four channels simultaneously to one display.
Input 1 (2, 3, 4): Turn this item on to feed each of the four channels of the server indi-
vidually.
Nickname: If desired you change the name of the Axis Quad Server(s). The default
names are [VIDEO 1], [VIDEO 2], [VIDEO 3], [VIDEO 4]. You can use a maximum of
20 characters. To change a name, tap [Nickname Input 1] (2, 3, 4) to show the soft-
ware keyboard. Change the name, then tap [] to finish. The name is reflected to the
following locations.
10-5
Advertisement
Table of Contents
