How To Follow A Route Selected From The Routes List; How To Start Navigation From A Route Point - Furuno NAVnet TZtouch2 Operator's Manual

5.10.2

How to follow a route selected from the routes list

1. Open the home screen, then tap [Lists] - [Routes].
2. Tap the route to follow then tap [Goto].
3. Tap the close button to finish.
The following occurs:
• The line for the selected route turns red.
• The go to point (1st route point) is highlighted.
• A thick red dashed line and a yellow line run between the current position and the
1st route point of the selected route. The thick red dashed line is the course to follow
to get to the 1st route point. The yellow line is the shortest course from the current
position to the go to point.
• The go to point is numbered "1". The starting point is indicated in the pop-up menu
item[Details] as [Start].
• The arrival area marker appears if activated on the menu (see subsection 5.11.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines and set their width with [Display XTE Lines] and [XTE Value] re-
spectively in [Routes] menu.
Note: If you want to be notified when you reach a goto point, turn on [Waypoint Cross-
ing Notification] in the [Routes] menu (see subsection 5.11.8). Then the message
"Waypoint Crossing" appears when you reach a goto point. For the arrival timing, see
subsection 5.11.5.
5.10.3

How to start navigation from a route point

Tap the route point of the route from where to start navigation, then tap [Start Nav] on
the pop-up menu.
In the above example, the following occurs:
• The route point "3" is selected to start navigation from, and is highlighted.
• The starting point is indicated in the pop-up menu item[Details] as [Start].
• The line from "3" to the route point "5" for the selected route turns red and the legs
for "0" and "1" turn gray.
• A thick red dashed line and a yellow line run between the current position "2" and
the "3" route point. The thick red dashed line is the course to follow to get to the
route point "3". The yellow line is the shortest course from the current position to the
route point "3".
• The arrival area marker appears if activated on the menu (see subsection 5.11.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines with [Display XTE Lines] in the [Routes] menu.
Note: If you want to be notified when you reach a goto point, turn on [Waypoint Cross-
ing Notification] in the [Routes] menu (see subsection 5.11.8). Then the message
"Waypoint Crossing" appears when you reach a goto point. For the arrival timing, see
subsection 5.11.5.
5. ROUTES
5-11