How To Show Or Hide All Routes; How To Set Route Density - Furuno NAVnet TZtouch2 Operator's Manual

5.8

How to Show or Hide All Routes

All routes (including the route information box) can be shown or hidden. Open the
[Layers] menu, the turn [Routes] on or off as required.
Note 1: An active route cannot be hidden from the screen unless route following is
stopped.
Note 2: Inactive routes can be placed at either the arrival or departure location. Open
the Layers menu, then activate [Departure] or [Arrival] (below the [Routes] flipswitch).
5.9

How to Set Route Density

If you display all your routes, the screen can become cluttered with routes. To prevent
this, set route density as shown below to limit the number of routes to show.
1. On the home screen, tap [Settings][Points][Routes Density] to show the fol-
lowing options menu.
2. Tap desired route density. [Low] is the lowest route density, and [Full] displays all
routes. Tap X on the title bar to close the menu.
5. ROUTES
5-9