13.2.2
How to Show or Hide all Data Boxes
You can show or hide all data boxes. Select [DataBox Display] at the bottom of the
[DataBox-General] menu then push the RotoKey to show or hide all data boxes. You
can also hide or show the data boxes with the DATA/VOL key.
13.2.3
How to Adjust Transparency of Data Boxes
You can adjust the degree of transparency for the data boxes with the [Transparency]
slider. The available degree of transparency is 0-80(%). (Alpha blending technology is
used for transparency effects.)
13.3
How to Set the Display Selection Window
Section 1.5 shows how to select a display at the display selection window. The default
display selection window provides five displays, identified as "hotpages," in configura-
tions according to the equipment that you have in your network. If the arrangement of
the hotpages does not meet your requirements, you can change the hotpages as nec-
essary. You can select the number of hotpages to show from five to ten and split a
hotpage up to four ways. For example, you can show the radar and fish finder displays
in a two-way split screen.
You can select how to split a hotpage by four different methods: full-screen, two-way,
three-way and four-way. The displays available depend on the screen division select-
ed and your system configuration. The table below describes screen division and pos-
sible display.
Screen division
Full
Two-way split
Three-way split
Four-way split
13.3.1
How to Set the Number of Hotpages to Show
Set the number of hotpages to show on the display selection window as follows:
1. Press the MENU key to open the
menu.
2. Open the [My NavNet-General] menu.
3. Use the RotoKey to select [Hotpage
Number].
4. Use the RotoKey to select a number.
5. Press the MENU key to close the
menu.
Possible display
Chart plotter, radar, camera, fish finder, weather facsimile
Chart plotter, radar, fish finder
Chart plotter, radar, fish finder
Chart plotter, radar, camera, fish finder, instrument
13. How to Adjust Settings
13-9