Micro Sd Cards - Furuno TZTL12F Operator's Manual

1. SYSTEM INTRODUCTION
1.10

Micro SD Cards

This equipment uses two types of micro SD cards, chart and data. The chart cards
contain charts and the data cards store plotter-related data such as tracks, routes,
points and generic data such as menu settings. (The SD card drive on the multi func-
tion display is for chart cards only. Use the SD card unit for data cards and chart
cards.) Set and remove the card as shown below. The Secure Digital Extended Ca-
pacity (SDXC) cards can also be used.
How to insert a micro SD card
Before inserting a chart card in the multi function display, turn off the power.
Unfasten two
screws.
Chart card drive (multi function display)
How to format a micro SD card
You do not normally need to format a data micro SD card. If the card becomes unread-
able, format the card with a formatting program that is compatible with the specifica-
tions of the card.
How to remove a micro SD card
1) Open the card drive cover.
2) Push the card to release the card from the card drive.
3) Remove the card with your fingers then close the lid (cover).
About the micro SD cards
• Handle the cards carefully. Improper use can damage the card and
destroy its contents.
• Make sure the slot lid (cover) is closed at all times.
• Remove a card with only your fingers. Do not use metal instruments
(like tweezers) to remove the card.
• Do not remove a card during the reading of or writing to the card.
Note: Use a micro SD card class 6 or higher for storing chart data.
1-20
Push card into slot
and close cover.
Push card
Open cover.
into a slot
and close
cover.
SD card unit (SDU-001)