Microsd Cards/Sd Cards - Furuno NAVNET TZ2 TZTL12F Operator's Manual

1.11

MicroSD Cards/SD Cards

This equipment uses microSD cards for chart cards and data storage (tracks, routes,
points, boundaries, catches, photos, and setting data. With use of the SDU-001 or a
SD card reader, SDXC (Secure Digital Extended Capacity) cards can also be used.
Note: TZT2BB generally uses only SD cards (inserted via the SDU-001), however if
the unit has microSD cards inserted inside the processor unit, microSD cards may be
used for charts and data storage.
How to insert a microSD card/SD card
Before inserting a chart card in the multi function display, turn off the power.
Unfasten two
screws.
Chart card drive (multi function display)
Peel the card slot
cover from the top end
to show the card slots.
Note: The TZT2BB does not recognize cards that are locked. Before inserting a card, check the
tab on the side of the card to be sure that the card is unlocked.
The TZT2BB has additional card slots inside of the processor unit (MPU-004). To use
the PBG (Personal Bathymetric Generator, see the section 8.7) feature, it is neces-
sary to insert a microSD card into one of the slots. Contact your dealer for details.
How to format a microSD card/SD card
You do not normally need to format a data microSD card. If the card becomes unread-
able, format the card with a formatting program that is compatible with the specifica-
tions of the card. Formatting a chart card will erase all chart data on the card.
For TZTL12F/TZTL15F For TZTL12F/TZTL15F
Push card into slot
and close cover.
For TZT2BB For TZT2BB
Protective
cover
For chart cards
Note: After installing the chart card, be sure to replace the protective cover.
For tracks, routes, points
and settings data cards
1. SYSTEM INTRODUCTION
Push card
Open cover.
into a slot
and close
cover.
SD card unit (SDU-001)
Remove the
protective cover
Install the data card in the right slot.
Install the chart
card in the left slot.
1-27