Midi Port Setup; Machine Control Section - Yamaha MIXING CONSOLE Owner's Manual

Digital mixing console
Table of Contents

Advertisement

212
Chapter 18—MIDI
• SLOT
If an optional "MY8-mLAN" I/O card is installed in the slot, MIDI data transfer to and from
an external MIDI device is available via the MY8-mLAN card. Up to eight-port MIDI data
(16 channels x 8 ports) can be transmitted and received.

MIDI Port Setup

Selecting a Port for MIDI Message Transfer
To configure MIDI ports for MIDI message transfer, press the DISPLAY ACCESS
[DIO/SETUP] button repeatedly until the DIO/Setup | MIDI/Host page appears. This page
enables you to set MIDI message input and output.
The following parameters are available on this page:
A
GENERAL section
This section enables you to select ports that transmit and receive MIDI messages, such
as Program Changes and Control Changes.
• Rx PORT ....................... This parameter specifies a port for general MIDI data recep-
• Tx PORT ....................... This parameter specifies a port for general MIDI data transmis-
B
MIDI THRU section
These parameters enable you to route incoming MIDI data from one port or slot to
another without changes. Select a port for reception in the first parameter box, and
select a port for transmission in the next parameter box (located to the right of the
arrow). If you select USB or SLOT, specify the port number in the small parameter box
adjacent to the port parameter box.
C

MACHINE CONTROL section

This section enables you to select a remote control method and a remote control port to
control external devices that support MMC, such as a hard disk recorder.
• PORT ............................. Select MIDI, USB, or SLOT (available only when an optional
01V96—Owner's Manual
1
2
3
tion. In the left parameter box, select MIDI, USB, or SLOT
(available only with an optional mLAN card installed). If you
select USB or SLOT, specify the port number (1–8) in the right
parameter box.
sion. The available ports are the same as for the Rx PORT
parameter.
mLAN card is installed) for MMC command transfer. If you
select USB or SLOT, specify the port number in the right
parameter box.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

01v96

Table of Contents