Pairing Input Channels - Yamaha MIXING CONSOLE Owner's Manual

92
Chapter 7—Input Channels

Pairing Input Channels

On the 01V96, you can pair adjacent odd-even Input Channels or counterpart channels on
Layer 1 and Layer 2 that share the same physical fader. Faders and most parameters of paired
channels are linked for stereo operation. Paired channels' linked parameters and non-linked
parameters (that are available for independent control) are listed below:
[SEL] buttons
Faders
Channel on/off
Insert on/off
Solo on/off
Solo Safe
Aux on/off
Aux Send level
Aux Sends as Pre or Post
Gate
Comp settings
EQ settings
Fader group
Mute group
Fade time
Recall Safe
Routing settings
Note: You cannot pair an ST IN channel 1–4 with an Input Channel.
To pair channels, or to cancel channel pairs, you can use the [SEL] buttons on the top panel
or access the Pair/Grup pages.
■ Pairing Channels by Using the [SEL] Buttons
1 While pressing and holding down the [SEL] button for one of the channels
you wish to pair, press the [SEL] button for the adjacent channel. (The paired
channel numbers should be odd and even in this order).
When the Pair Confirmation check box is on, the Channel Pairing window appears.
Note: You can pair only channels that are adjacent, odd-even (in this order) channels. Pressing
the [SEL] button for a non-adjacent channel will be ignored. You cannot create or cancel a
pair of vertical partners.
01V96—Owner's Manual
Linked parameters Non-linked parameters
Input patches
Insert patches
Output patches
Comp insert position
Phase
Delay on/off
*
Delay time
Delay feedback
Delay mix
Routing
Pan, Follow Pan
Surround pan
Aux Send pan
Balance
**
Attenuators
* You can set this parameter for each channel independent-
ly if the GANG button is turned off on the
| DLY page.
** You can set this parameter for each channel independent-
ly on the EQ | ATT page, but the paired channel settings
are linked on the EQ | Edit and View pages.
/INS/DLDLY