Overdubbing To Other Tracks - Yamaha MIXING CONSOLE Owner's Manual

60
Chapter 5—Tutorial
Tip: If the digital MTR supports MMC (MIDI Machine Control) commands, you can use
the 01V96's Machine Control function to select tracks or locate a position on the recorder from
the 01V96 (see page 208).

Overdubbing to Other Tracks

This section describes how to overdub the musical instruments or microphone connected
to the INPUT connectors 1 and 2 to the digital MTR's Tracks 9 and 10, while listening to the
performance recorded on Tracks 1–8.
Setting the Input Levels
1 Connect the musical instruments to INPUT
connectors 1 and 2, and adjust the corre-
sponding [PAD] switches and [GAIN] con-
trols so that the [PEAK] indicators
temporarily flash at the highest volumes.
2 Press the LAYER [1–16] button.
Input Channel Layer 1–16 is now available for control from the channel strip section.
3 Press the DISPLAY ACCESS [HOME] button, then press the [F1] button to dis-
play the Meter | CH1-32 page.
4 Make sure that [ON] button indicators for the channels to which the instru-
ments or microphone are connected are lit, then raise the corresponding
faders to 0dB.
Turn off the [ON] buttons for the channels not in use.
5 While the musicians play the musical instruments, check the input channel
levels using the level meters on the display.
01V96—Owner's Manual
PAD [PAD] switch
20dB
[GAIN] control
-16 -60
GAIN
[PEAK] indicator
PEAK