Gain Controls; Monitor Source Selector - Yamaha MIXING CONSOLE Owner's Manual

D PAD switches
These switches turn on or off the 20 dB pad (attenuator) for each AD Input.
E GAIN controls
These controls adjust input sensitivity for each AD Input. Input sensitivity is –16 dB to
–60 dB when the Pad is off, and +4 dB to –40 dB when the Pad is on.
F PEAK indicators
These indicators light up when the input signal level is 3 dB below clipping. Adjust the Pad
switch and GAIN control so that the indicator rarely lights up at signal peak.
G SIGNAL indicators
These indicators light up when the input signal level exceeds –34 dB.
H AD15/16 selector
This button selects AD Input Channel 15 and 16 signals. When the button is turned on
(pushed in), the 2TR IN signals (page 24) are selected. When the button is turned off
(raised), the INPUT 15 and 16 signals are selected.
Monitor Out & Headphones Section
A 2TR IN/OUT connectors
These unbalanced RCA phono connectors input and output line-level signals, and are typ-
ically used to connect a master recorder.
When the AD15/16 selector in the AD Input section ( 8 ) is turned on (pushed in), the sig-
nals input at the 2TR IN connectors are routed to AD Input Channels 15 and 16. When the
Monitor Source selector ( 2 ) is turned on (pushed in), you can monitor the 2TR IN signals
from the MONITOR OUT connectors.
The 2TR OUT signals are always the same as the STEREO OUT signals.
B Monitor Source selector
This button selects the signals output from the MONITOR OUT connectors on the rear
panel. When this button is turned on (pushed in), you can monitor the signals input from
the 2TR IN connectors. When the button is turned off (raised), you can monitor the Stereo
Out signals or soloed channel signals.
C MONITOR LEVEL control
This control adjusts the monitoring level of the signals output from the MONITOR OUT
connectors.
D PHONES LEVEL control
This control sets the level of the PHONES. (See page 131 for more information on moni-
toring through the headphones.)
E PHONES jack
You can connect a set of stereo headphones to this stereo phone jack. The signals output
from the MONITOR OUT connectors are also output from this jack.
CH5-8 CH9-12
PHANTOM +48V
L
1
R
IN OUT
2TR
-10dBV
(UNBAL)
PHONES
2
MONITOR
2TR IN
3
0 10 0 10
LEVEL LEVEL
MONITOR PHONES
OUT
Control Surface
5
4
01V96—Owner's Manual
15
2