Setting The Transfer Format For Higher Sampling Rates - Yamaha MIXING CONSOLE Owner's Manual

Setting the Transfer Format for Higher Sampling Rates

To operate the 01V96 at higher sampling frequencies (88.2 kHz or 96 kHz) and transfer dig-
ital audio signals to and from connected external devices, you must set the data transfer for-
mat in accordance with the sampling frequencies supported by the external devices.
1 Press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the
DIO/Setup | Word Clock page appears.
2 Select INT88.2k or INT96k as the wordclock source.
3 Press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the
DIO/Setup | Format page appears.
4 Use the cursor buttons to move the cursor to an IN/OUT parameter field
1
( ), then rotate the Parameter wheel or press the [INC]/[DEC] buttons to
set the data transfer format.
The IN/OUT parameters are used to set one of the following data transfer formats for each
slot input and output.
• DOUBLE CHANNEL
In Double Channel mode, digital audio data is received and transmitted as mono signals at
a sampling rate that is exactly half (44.1/48 kHz) the current higher sampling rate. Data is
handled by two channels. This is useful when you wish to transfer data between the 01V96
running at a higher sampling rate and legacy 44.1/48 kHz digital MTRs or HDRs.
Note:
• Double Channel mode reduces the total number of inputs or outputs on the corresponding
slot. The even-numbered channels are disabled.
• You cannot select this mode unless the 01V96 is operating at a high sampling rate.
• DOUBLE SPEED
In Double Speed mode, digital audio data is received and transmitted at the current high
sampling rate (i.e., 88.2 kHz or 96 kHz). Select this mode if the devices that support the
higher sampling rates transmit or receive data.
Note: This mode is available only for the slot in which the optional Yamaha MY8-AE96 or
MY8-AE96S Digital I/O card is installed.
Setting the Transfer Format for Higher Sampling Rates
1
75
01V96—Owner's Manual
6