Table of Contents
Advertisement
192
Chapter 17—Remote Control
Control Surface Operation
When the Pro Tools Remote layer is selected, the 01V96 controls on the top panel engage
the following functions:
■ Channel Strip section
• [SEL] buttons
These buttons select Pro Tools channels, inserts, and Automation mode.
• [SOLO] buttons
These buttons solo Pro Tools channels. The button indicators for the soloed channels light
up.
• [ON] buttons
These buttons mute Pro Tools channels.
• Faders
The faders set Pro Tools channel levels, including the audio tracks, MIDI tracks, master
fader, Aux Ins, etc. If 16 or fewer channels are displayed in Pro Tools, faders are assigned
starting from the left-most channel.
■ FADER MODE Section
• [AUX 1]–[AUX 5] buttons
These buttons select Sends A–E so that you can adjust the corresponding Pro Tools channel
send level.
• [AUX 6] button
Press and hold down this button and press the desired [SEL] button to reset the correspond-
ing channel fader level.
Move the cursor to the parameter control on the display, then press and hold down this but-
ton and press [ENTER] to reset the corresponding channel panpot to center. While you are
holding down the [AUX 6] button, the SELECT ASSIGN parameter indicates "DFLT."
• [AUX 7] button
When this button is turned on, you can adjust the selected channel panpot using the
SELECTED CHANNEL [PAN] control. If you turn on this button while a Channel Display
mode page is selected, you can adjust each channel panpot using parameter controls 1–16.
To adjust the stereo channel panpots, press this button repeatedly to toggle between L and
R channels.
• [AUX 8] button
Use this button along with the desired [SEL] button to assign a plug-in to the corresponding
Pro Tools channel (see page 198).
• [HOME] button
This button turns Flip mode (see page 197) on or off. Flip mode enables you to adjust the
Aux Send parameters using the faders, [ON] buttons, and the [PAN] control.
01V96—Owner's Manual
Advertisement
Table of Contents
