Inserting The Internal Effects Into Channels - Yamaha MIXING CONSOLE Owner's Manual

156
Chapter 14—Internal Effects

Inserting the Internal Effects into Channels

You can insert the internal effects into certain Input Channels or Output Channels (Bus
1–8, Aux Bus 1–8, or the Stereo Bus).
Note:
• You cannot use Insert In and Out for ST IN Channels.
• If effects are inserted in channels, you cannot use those effects via Aux Sends or insert them
into other channels.
1 Select an internal Effects processor (1–4), then recall the desired effect pro-
grams.
2 Press the [SEL] button of the Input Channel or Output Channel into which
you want to insert the selected effects.
Tip: Repeatedly pressing the STEREO [SEL] button toggles between the left and right Stereo
Bus channels.
3 Press the DISPLAY ACCESS [
/Ins/Dly | Insert page appears.
4 Select the effect insertion position using the INSERT button in the POSITION
section.
5 Move the cursor to the OUT parameter box in the INSERT section, then select
the inputs of the effects processor selected in Step 1.
• FX1-1 & FX1-2 ............. Inputs 1 & 2 of Internal Effects Processor 1
• FX2-1 & FX2-2 ............. Inputs 1 & 2 of Internal Effects Processor 2
• FX3-1 & FX3-2 ............. Inputs 1 & 2 of Internal Effects Processor 3
• FX4-1 & FX4-2 ............. Inputs 1 & 2 of Internal Effects Processor 4
6 Press [ENTER] to confirm the setting.
7 Move the cursor to the IN parameter box in the INSERT section, select the
outputs of the effects processor selected in Step 1, then press [ENTER] to
confirm the setting.
8 Move the cursor to the ON/OFF button in the INSERT section, then press
[ENTER] to turn on the button.
Effect insertion is now enabled.
01V96—Owner's Manual
/INSERT/DELAY] button repeatedly until the