Using The Oscillator - Yamaha MIXING CONSOLE Owner's Manual

230
Chapter 19—Other Functions

Using the Oscillator

The 01V96 features an Oscillator you can use for sound checks. Follow the steps below to
use the Oscillator:
1 Press the DISPLAY ACCESS [UTILITY] button repeatedly until the Utility |
Oscillator page appears.
This page contains the following parameters:
A
OSCILLATOR ON
This parameter button turns the Oscillator on or off.
B
WAVEFORM
These parameter buttons select the Oscillator waveforms.
C
LEVEL section
The parameter control in this section sets the Oscillator output level.
D
ASSIGN section
The buttons in this section select the Oscillator output.
2 Move the cursor to the button for the Oscillator output channel in the
ASSIGN section, then press [ENTER] (you can select multiple channels).
3 Move the cursor to one of the WAVEFORM parameter buttons, then press
[ENTER].
You can select the following waveforms:
• SINE 100Hz .................. 100 Hz sinewave
• SINE 1kHz .................... 1 kHz sinewave
• SINE 10kHz .................. 10 kHz sinewave
• PINK NOISE ................ Pink noise
• BURST NOISE ............. Burst noise (200 msec pink noise pulses at four second inter-
4 Move the cursor to the parameter control in the LEVEL section, then rotate
the Parameter wheel to set the Oscillator level to minimum.
Note: Sinewave and pink noise create unusually high sound pressure. Oscillator levels that
are too high can damage the speakers. When you use the Oscillator, be sure to set the level to
minimum, then raise the level gradually.
5 Move the cursor to the OSCILLATOR ON/OFF button, then press the [ENTER]
or [INC]/[DEC] buttons to turn on the Oscillator.
The Oscillator signal is now routed to the channels selected in the ASSIGN section.
01V96—Owner's Manual
1
2
vals)
3
4