Pentax DSI-200 Series User Manual page 78

Set
Function
value
selection terminal
2
Frequency source
18
switching
UP/DOWN set
0 （terminal、
19
keyboard）
Run command to
20 switch the
terminal 1
Acceleration/
21 deceleration is
prohibited
22 PID stop
23 PLC statue reset
24 Pendulum pause
25 Register input
26 Register reset
Length count
27
input
28 Length reset
Torque control
29
disabled
High speed pulse
input setting
30 （Only valid for
S5）
31 keep
Used to switch between different frequency sources.
Depending on the frequency source selection function code
(P0-07) is set when setting between two frequency sources
When the frequency is given as a digital frequency reference,
this terminal can clear the terminal UP / DOWN or Keyboard
UP / DOWN changes the frequency value, so that the given
frequency to restore the value set to P0-08.
When the run command is set to terminal control (P0-02 = 1),
this terminal can be terminal controlled with Keyboard control
switch.
Ensure that the frequency converter is not affected by external
signals (except for the stop command), to maintain the current
output frequency.
PID Temporary failure, the inverter to maintain the current
output frequency, no longer the frequency of the source PID
adjustment.
When the PLC is paused during execution, the inverter can be
restored to this time through this terminal
Simple PLC initial state.
The frequency converter outputs at the center frequency. The
wobble function is paused.
The input terminal of the count pulse.
The counter status is cleared.
Length count input terminal.
The length is cleared
Prohibit the inverter torque control, the inverter into the speed
control mode
S5 as a high-speed pulse input terminal function.
keep
- 78 -
Description