Pentax DSI-200 Series User Manual page 5


If the parameter identification is required, pay attention to the danger of injury
arising from the rotating motor. Otherwise accident may occur.

Do not change the factory settings at will. Otherwise it may damage the
equipment.
During the Operation

Do not touch the fan, heat sink or discharge resistor to sense the temperature.
Otherwise, you may get burnt.

Detection of signals during the operation shall only be conducted by qualified
technician. Otherwise, personal injury or equipment damage may be caused.

Do not control run/stop by using contactor. Or equipment damage may be
caused!

Avoid anything falling into the equipment when inverter is running. Or damage
may be caused.
Maintenance

Do not perform professional training personnel Do not carry out maintenance
and maintenance of the inverter. Otherwise it is personal injury or equipment
damage!

Do not charge the equipment for repair and maintenance. Otherwise there is
danger of electric shock!

After confirming that the input power of the inverter is de-energized for 10
minutes, the drive can be maintained and serviced. Otherwise the residual
charge on the capacitor will cause harm to people!

All pluggable plug-ins must be plugged in the case of power failure!

After the Inverter is replaced, the parameters must be set and checked.
2. Product Information
2.1 Name rule
–
DSI-200 004G3/5K5P3
Figure 2-1 Name rule
5
Caution
Warning
Caution
Warning