Pentax DSI-200 Series User Manual page 109

Timing function
P8-42
Setting Range
Running time setting
channel
P8-43
Setting Range
Running time
P8-44
Setting Range
This set of parameters is used to set the timing function of the inverter.
When the P8-42 timing function is selected, the frequency inverter starts the timing ,after
reaching the set running time, the frequency inverter automatically stops, and the multi-
function terminal HDY outputs the ON signal.
Each time the inverter starts, it starts clocking from 0, and the remaining running time can
be checked by d0-20.
The run time is set by P8-43 and P8-44, and the time unit is minute
AI1 input voltage lower
limit
P8-45
Setting Range
AI1 input voltage upper
limit
P8-46
Setting Range
When the analog input AI1 is greater than P8-46, or the AI1 input is less than P8-45, the
inverter multi-function terminal HDO outputs "AI1 input more than limitation" of ON
signal, which is used to indicate whether the input voltage of the AI1 is within the set
range.
IGBT temperature
threshold
P8-47
Setting Range
Figure 6-23 Current detection
Factory default
0：invalid
Factory default
0：set by P8-44
2：AI2
(100% of analog input corresponds to the value of P8-44)
Factory default
Factory default
Factory default
Factory default
- 109 -
0
0
1：AI1
3：AI3
0.0Min
0.0Min～6500.0Min
3.10V
0.00V～P8-46
6.80V
P8-45～10.00V
75℃
0.00V～P8-46
1：valid