Pentax DSI-200 Series User Manual page 67

Motor 1
P1-03 rated
current
Motor 1
P1-04 rated
frequency
Motor 1
P1-05
rated rmp
Asynchron
ous motor
P1-06 1 stator
power
Resistance
Asynchron
ous motor
P1-07 1 rotor
electric
Resistance
Asynchron
ous motor
P1-08
1 leakage
inductance
Asynchron
ous motor
P1-09
1 mutual
inductance
Asynchron
ous motor
P1-10 1
No-load
current
Number of
P1-27 encoder
lines
0.01A ～ 655.35A
Model
( AC motor frequency≤
determined
0.01Hz ～max
Model
determined
Model
1rpm ～ 65535rpm
determined
0.001Ω ～ 65.535Ω
Model
( AC motor frequency≤
determined
0.001Ω ～ 65.535Ω
Model
( AC motor frequency≤
determined
0.01mH ～ 655.35mH
Model
( AC motor frequency≤
determined
0.1mH ～ 6553.5mH
Model
( AC motor frequency≤
determined
0.01A ～ P1-03
Model
( AC motor frequency≤
determined
1 ～ 65535
1024
- 67 -
Closely related.
55kW)
frequency
55kW)
P1-06 ~ P1-10 is the parameters
of the induction motor, can be
obtained through the motor self-
learning. Among them, the
asynchronous part of the
55kW)
asynchronous parameters of self-
learning can only get P1-06 ~ P1-
08 three parameters,
asynchronous machine dynamic
55kW) complete learning can get P1-06 ~
P1-10, you can also get the
encoder phase sequence P1-30. If
the scene is not on the motor self-
learning, according to the motor
55kW)
manufacturers to provide the
parameters, enter the
corresponding function code.
55kW)
Set the number of pulses per
revolution of the encoder. In the
speed sensor vector control mode
(FVC), the number of encoder
pulses must be set correctly,
otherwise the motor will not run
normally.