Pentax DSI-200 Series User Manual page 127

Easy PLC paragraph 14
acceleration /
PC-47
deceleration
Set range
Simple PLC fifteenth run
time
PC-48
Set range
Easy PLC paragraph 15
PC-49 acceleration /
deceleration
Set range
Simple PLC run time
PC-50
Set range
Multi-step instruction 0
given mode
PC-51
Set range
This parameter determines the given channel for multi-step instruction 0.
In addition to the PC-00, there are a number of other options that allow you to toggle
between multiple short and other ways. In the multi-segment instructions as a frequency
source or simple PLC as a frequency source, can easily achieve the two frequency source
switching
Pd Group Communication parameters
Please refer to "communication protocol"
PP Group user password
User password Factory default
PP-00
Set range
PP-00 set any non-zero number, the password protection function to take effect. The next
time you enter the menu, you must enter the correct password, or cannot view and modify
the function parameters, please keep in mind the user password set. Set the PP-00 to 00000,
then clear the set user password, so that the password protection function is invalid.
A0 Group Torque control and qualification
Speed / torque control
mode selection
A0-00
Set range
Used to select the inverter control mode: speed control or torque control.
DSI-200 multi-function digital S terminal, with two torque control related functions: torque
control disabled (function 29), speed control / torque control switch (function 46). The two
Factory default
Factory default
Factory default
Factory default
unit
Factory default
0: Function code PC-00 reference
3: AI3
6: Preset frequency (P0-08) is given, UP / DOWN can be
modified
Factory default
0: Speed control
0～3
0.0s（h）～6553.5s（h）
0～3
0：S（s）
4: High speed pulse input
0～65535
1: Torque control
- 127 -
0
0.0s（h）
0
0
1：h（h）
0
1: AI1 2: AI2
5: PID
0
0