Inspect - AT&T SYSTEM 25 User Manual

Inspect

The inspect mode allows you to use your console display to get
the following information:
The PDC and associated name for a call on hold or ringing at
a (LOOP) button.
The number of trunks available in a group of trunks
represented by a
The number or code stored on a (REP DIAL) , (LAST # DIALED) ,
(FLEX DSS)
or
The name of the feature assigned to any other button.
In the Inspect mode, your console is unavailable
NOTE:
to new incoming calls. In addition, you will not be able
to perform call-handling procedures (holding,
transferring, answering a call, etc.).
Using the Inspect Feature
1 Press (INSPECT) .
2 Press the button you want to inspect.
Deactivating the Inspect Feature
When you do any of the following, you automatically deactivate
the Inspect feature:
Press (INSPECT) again.
Hang up the handset after being off-hook, lift the handset
after being on-hook, or press an idle (LOOP) button.
Allow the display to be idle for 15 seconds.
32
(FACILITY)
button.
button.
(Continued)