Inspect 2 - 5 - AT&T SYSTEM 25 Manual

This feature applies to display voice terminals only.
The Inspect Mode allows display set users to obtain the following information:
The PDC and associated name for a call that is either ringing or on hold at a
SYSTEM ACCESS or BRIDGED ACCESS button.
The number of trunks available in a trunk group represented by a FACILITY
button.
The numbers stored on a REP DIAL, LAST # DIALED, or FLEX DSS button.
The name of the feature assigned to any other administrable button.
While in Inspect Mode, the voice terminal is not available to new incoming calls, nor can it
perform call-handling procedures (holding, transferring, answering a call, etc.).
If the user press INSPECT immediately after dialing a call, the call may be
NOTE:
disconnected; a pause of several seconds is recommended.
Identifying a Call that is Ringing or on Hold. The display is identical to the one that
appeared when the call first came in, as in these examples:
Identifying Numbers Stored on Buttons.
Number Dialed, or Repertory Dialing button will be displayed. For example:
If no number is currently stored, the feature name is displayed. For example:
I n s p e c t
329 Asay, J
or
OUTSIDE
The number that is stored on a Flexible DSS, Last
912015556543
FLEX DSS
I n s p e c t 2-55