Using Netware Utilities - Xerox WorkCentre PE120i System Administration Manual

Using NetWare Utilities

Installation Procedure
There are three stages required to install the WorkCentre PE120i on a NetWare network using
NetWare utilities:
Network Communication Setup
NetWare Setup
Test Print
If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre PE120i.
Network Communication Setup
At the WorkCentre PE120i, perform these steps:
HINT:
WorkCentre PE120i, refer to the Internet Services chapter for instructions.
Ensure that the Basic TCP/IP settings have been configured (see "Network
1
Communication Setup" on page 2-5).
2
Xerox WorkCentre PE120i System Administration Guide
This procedure will enable the WorkCentre PE120i to communicate on the
NetWare network.
This procedure is used to setup the network using NetWare utilities, for
example NWADMIN.
A print job should be submitted to ensure the WorkCentre PE120i has been
installed and configured correctly.
Xerox CentreWare Internet Services can also be used to configure the
Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]
Page 3-5