Appletalk Installation; Installation Procedure; Network Communication Setup - Xerox WorkCentre PE120i System Administration Manual

AppleTalk Installation

Installation Procedure

There are two stages required to install the WorkCentre PE120i on an AppleTalk network:

Network Communication Setup

Print Driver Installation
Test Print
Network Communication Setup
This procedure is used to setup the network communication parameters of the WorkCentre
PE120i.
At the WorkCentre PE120i, perform these steps:
HINT:
WorkCentre PE120i, refer to the Internet Services chapter for instructions.
Connect the device to the network outlet or cable.
1
2
Xerox WorkCentre PE120i System Administration Guide
This requires the WorkCentre PE120i to be setup for AppleTalk.
A test print should be submitted to ensure the WorkCentre PE120i has been
installed and configured correctly.
Xerox CentreWare Internet Services can also be used to configure the
Press [Menu] until you see
Network Setup on the top line of
the display.
8. Network Setup
[Reset Network]
Page 5-3