Xerox WorkCentre PE120i System Administration Manual page 78

Obtain and record the following information from the setup just completed. This
6
information is needed to configure the device with CentreWare Internet Services:
Continue with Configure the WorkCentre PE120i.
7
Configure the WorkCentre PE120i
To complete the installation of the WorkCentre PE120i, perform these steps:
Enable CentreWare Internet Services (see "Enabling Internet Services" on page 6-5).
1
At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the
2
[Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
3
and then select the [+] symbol to the left of the Protocols folder.
In the Properties frame, within the Physical Connections folder, select [NetWare].
4
Make the following selections and settings in the General section of the Protocols frame:
5
Select the checkbox to enable NetWare.
Choose the [Frame Type].
Set the [Queue Poll Interval].
This value determines how often the WorkCentre PE120i polls the NetWare file server to
check if there is a file at the server to be printed or faxed. Enter a value from 10 to 240
seconds.
Enter the [Print Server] name. Use a meaningful name, such as the location of the
device.
NOTE: The Printer Server Name must match that entered using PConsole or the
NW Admin utility.
Page 6-12
File Server Name
Print Server Name
Print Server Password
Frame Type
Xerox WorkCentre PE120i System Administration Guide