Netware - Xerox WorkCentre PE120i System Administration Manual
Xerox system administration guide printer workcentre pe120i
Hide thumbs
Also See for WorkCentre PE120i:
- Evaluator manual (8 pages) ,
- User manual (283 pages) ,
- Service manual (145 pages)
Table of Contents
Advertisement
NetWare
Use these instructions to install WorkCentre PE120i on a NetWare network using CentreWare
Internet Services.
Installation Procedure
There are three stages required to install the WorkCentre PE120i on a NetWare network using
CentreWare Internet Services:
PCONSOLE or NWADMIN Setup
Configure the WorkCentre PE120i
Test Print
PCONSOLE or NWADMIN Setup
If running NLSP, be sure that RIP/SAP compatibility is configured on the same segment as the
WorkCentre PE120i.
Using the PCONSOLE or NWADMIN utility, perform the following steps:
Login to File Server as Supervisor or equivalent.
1
Create the Print Queue.
2
Create Print Server Name and Password.
3
Define the printer as Defined Elsewhere or Remote/Other Unknown.
4
Verify the Frame Type.
5
Xerox WorkCentre PE120i System Administration Guide
This procedure is used to setup the network using NetWare's PCONSOLE or
NWADMIN utility.
This procedure explains how to use CentreWare Internet Services to
configure the WorkCentre PE120i.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Page 6-11
Advertisement
Table of Contents
