Http - Xerox WorkCentre PE120i System Administration Manual

HTTP

Use these instructions to setup HTTP using CentreWare Internet Services.
NOTE: The HTTP settings for the device will have been setup when completing the
Enabling CentreWare Internet Services section.
To complete the installation of the device, perform these steps:
Enable CentreWare Internet Services (see "Enabling Internet Services" on page 6-5).
1
At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the
3
[Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
4
and then select the [+] symbol to the left of the Protocol folder.
Check the HTTP Configuration details are correct. If necessary.
5
Enter the [Keep Alive Timeout] in seconds from 5 to 99.
Enter the [Maximum Connections] from 5 to 16.
Click the [Apply] button to implement any changes.
6
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
Select the [Status] tab and then select [Reset Network Controller] to enable the
7
selections to take effect.
Continue with Test Print.
8
Page 6-26 Xerox WorkCentre PE120i System Administration Guide