Xerox WorkCentre PE120i System Administration Manual page 90

IPP
Use these instructions to setup IPP using CentreWare Internet Services.
NOTE: The HTTP settings for the device will have been setup when completing the
Enabling CentreWare Internet Services section.
To complete the installation of the device, perform these steps:
Enable CentreWare Internet Services (see "Enabling Internet Services" on page 6-5).
1
At the CentreWare Internet Services Home Page for the WorkCentre PE120i, select the
2
[Properties] tab.
Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame,
3
and then select the [+] symbol to the left of the Protocols folder.
Select [IPP].
4
Select the checkbox to enable IPP.
Check the IPP Configuration details are correct. If any of the details are incorrect then
enter
Click the [Apply] button to implement any changes.
5
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
Select the [Status] tab and then select [Reset Network Controller] to enable the
6
selections to take effect.
Continue with Test Print.
7
Page 6-24
the required configuration details in the appropriate boxes.
Xerox WorkCentre PE120i System Administration Guide