Windows Xp (Tcp/Ip) - Xerox WorkCentre PE120i System Administration Manual

Windows XP (TCP/IP)

NOTE: Windows XP supports printing via TCP/IP as standard when TCP/IP is
installed on a Windows XP Workstation.
Use the Add Printer Wizard to add the WorkCentre PE120i to the network.
Select [Start], select [Printers and Faxes].
1
Double-click on the [Add Printer] icon to display the Add Printer Wizard.
Select [Local Printer attached to this computer], uncheck the box labelled
2
[Automatically detect and install my Plug and Play printer.]and then select [Next] to
display the
Select [Create a new port] to display the Printer Ports
3
Select [Standard TCP/IP Port] and select [Next] to display the Add Standard TCP/IP Port
dialog
Enter the IP Address of the printer in the [Name or address of printer] field (you can
optionally enter a friendly name for the printer port you are creating or use the default
name created). Then select [Next] to continue.
If the network printer settings are not automatically detected, click on the [Custom] button
to setup the network printer port settings.
It is recommended that you select [RAW] as the Print Protocol.
If you prefer to use LPR:
Select [LPR] as the Print Protocol.
Enter [lp] (in lower case) in the [LPR print queue] field.
Uncheck the box labelled [LPR Byte Counting Enabled]
Check the box labelled [SNMP Status Enabled].
The [Community Name] should normally be set to "public" (unless you have configured
the device to have a custom SNMP community name) and the [SNMP Device Index]
should be set to 1.
Select [OK].
The Add Printer Wizard will then request that you select the driver to be used for this
4
printer.
Insert the CD ROM with the WorkCentre PE120i drivers into the workstation and select
[Have Disk].
Page 4-4
dialog box listing available ports.
box.
dialog
Xerox WorkCentre PE120i System Administration Guide
box.