Xerox 6100 User Manual page 137

This status message...
IDLE
INNER JAM
MEDIA MISMATCH
MISFEED JAM
NO PRNTREQ ERROR
OPTIONAL BIN REAR DOOR
OPEN
OUTER JAM
OUTPUT BIN FULL
OUTPUT BIN JAM
PROCESSING...
PUT SIZE PAPER IN ANY BIN
Printer Jams and Troubleshooting
means...
The printer is on line, but no jobs
are in process.
Media has jammed leaving the
OPC belt cartridge area.
The media detected in the
cassette doesn't match the
media size setting.
Media has jammed between the
cassette and the print engine.
A printer hardware error has
occurred.
The lower feed unit (optional)
rear door is open.
Media has jammed between the
print engine and the output tray.
The media has exceeded the
limit (such as over 250 sheets of
20 lb [75 g/m²] bond) in the
output bin.
A media jam has been detected
between the fuser and output
tray rollers located near the top
cover.
The printer is currently
processing a print job.
Engine/Chain Inputbins is set to
On and a chained cassette is
empty.
Status and Service
Messages
Do this...
No action needed.
Locate and remove the
jam.
Change the media in the
cassette or change the
media size setting.
Locate and remove the
jam.
Reboot the printer. If this
message continues to
appear, contact your
service provider. (Refer
to www.minolta-qms.com
for a complete list.)
Close door.
Locate and remove the
jam.
Remove the media from
the output bin.
Locate and remove the
jam.
No action needed.
Refill the cassette with
the specified size media.
6-17