Xerox 6100 User Manual page 119

4 If you need to remove a DIMM
before installing one, remove it
as follows; otherwise skip to
step 5.
» Note: If both DIMM connectors are
filled and you want to install more
memory, you must remove both
DIMMs and install one DIMM of a
greater memory capacity or install
two DIMMS of equal size.
a Using both thumbs, pull the
latches (one on each side of
the DIMM connector) outward.
b Lift the DIMM straight out of the
DIMM connector.
5 Remove the new DIMM from its antistatic bag.
» Note: Observe the keyed side of the DIMM to align it with the connector.
6 Insert the new DIMM straight
down into the DIMM connector
until the latches snap into the
locked position.
When seated, the DIMM stands
upright, firmly in place. If you can-
not snap the DIMM into place, do
not force it. Reposition it, making
sure that the bottom of the DIMM is
seated completely in the connector.
7 Repeat steps 5–6 for each
additional DIMM that you install.
8 Reinstall the controller board
into the printer.
Gently slide the controller board into the printer until it is fully seated, and then
tighten the two screws.
9 Reconnect all interface cables.
Options
Dual In-Line Memory
Modules
5-15