Table of Contents
Advertisement
The firmware will now be sent to the TIGER Select. A bar at the bottom of the screen will indicate
the progress of the update.
The new version will be shown on the screen.
Important: Do not disconnect the TIGER Select at this point. Follow the
instructions below before disconnecting.
After the upgrade been sent to the TIGER Select, the instrument will install it. The TIGER Select will
flash the two torch LEDs. The screen on the TIGER Select will remain blank for about 30 seconds. A
progress bar will then be displayed as the installation takes place:
A 'verifying file system' message will then be displayed.
The firmware is now installed on the instrument. It will then restart automatically.
Unrivalled Gas
Detection.
TIGER Select Instrument User Manual V3.2
Page 47 of 73
ionscience.com
Advertisement
Table of Contents
