Table of Contents
Advertisement
Calibration
By default, key B will be set to the Calibration function, as in Basic Mode. See
above for general details of the Calibration options, and the
calibration procedures.
Options
The Options soft key accesses several instrument settings. These can also be configured using:
•
Time and Date
To adjust the time and date via the instrument, use the Up and Down keys to select the date
or time and press Enter. Then use the Up and Down keys to adjust the values, as required.
Confirm settings with Enter.
•
Backlight
Refer to the
TigerPC Configuration Screen
preferred option with the Up and Down keys and confirm with Enter. Note that if the limited
time option is selected, the time is set using TigerPC.
•
Sound
Refer to the
TigerPC Configuration Screen
preferred option with the Up and Down keys and confirm with Enter.
For percentage volume, press Enter again to confirm selection. The frame will flash. Use the
Up and Down keys to change the percentage volume and press Enter to confirm the chosen
value.
•
Alarms
Upper and lower alarms levels for the selected gas are taken from gas tables. They can be
changed using
Upper
and lower
Down keys and press Enter. The arrow(s) on the chosen alarm will flash. Adjust the level
using the Up and Down keys and press Enter. Repeat if necessary for the other alarm.
The lower alarm setting should never be greater than the upper alarm. Therefore,
if the lower alarm is set to higher than the upper alarm, the upper alarm is
automatically incremented to the lower alarm level plus 1.
•
Units
Refer to the
TigerPC Configuration Screen
available units by using the Up and Down keys and then pressing Enter.
Unrivalled Gas
Detection.
TigerPC, or via this option.
alarm options are displayed. Select an alarm using the Up and
Page 21 of 73
TIGER Select Instrument User Manual V3.2
Calibration
section for full details on
topic for details of these options. Select the
topic for details of these options. Select the
topic for details of these options. Select from the
Key B: Calibration
ionscience.com
Advertisement
Table of Contents
