Ftp Command Line Procedure; Gui-Based Ftp Clients; Ftp Restrictions - ZyXEL Communications GS1920v2 Series User Manual

WARNING ! Be sure to uplo a d the c o rre c t m o de l firm wa re a s uplo a ding
the wro ng m o de l firm wa re m a y da m a g e yo ur de vic e .
39.7.3 FT P C o m m a nd L ine Pro c e dure
Launch the FTP client on your computer.
1
Enter open, followed by a space and the IP address of your Switch.
2
Press [ENTER] when prompted for a username.
3
Enter your password as requested (the default is "1234").
4
Enter bin to set transfer mode to binary.
5
Use put to transfer files from the computer to the Switch, for example, put firmware.bin ras transfers
6
the firmware on your computer (firmware.bin) to the Switch and renames it to "ras". Similarly, put
config.cfg config transfers the configuration file on your computer (config.cfg) to the Switch and
renames it to "config". Likewise get config config.cfg transfers the configuration file on the Switch
to your computer and renames it to "config.cfg". See
filename conventions.
Enter quit to exit the ftp prompt.
7
39.7.4 G UI- b a se d FT P C lie nts
The following table describes some of the commands that you may see in GUI-based FTP clients.
General Commands for GUI-based FTP Clients
C O MMAND
Host Address
Login Type
Transfer Type
Initial Remote Directory
Initial Local Directory
39.7.5 FT P Re stric tio ns
FTP will not work when:
• FTP service is disabled in the
• The IP address(es) in the
not match, the Switch will disconnect the FTP session immediately.
Chapter 39 Maintenance
DESC RIPT IO N
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the server for
anonymous access. Anonymous logins will work only if your ISP or service administrator
has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode. Configuration and
firmware files should be transferred in binary mode.
Specify the default remote directory (path).
Specify the default local directory (path).
Se rvic e Ac c e ss C o ntro l
Re m o te Ma na g e m e nt
GS1920v2 Series User's Guide
347
Table 167 on page 346
screen.
screen does not match the client IP address. If it does
for more information on