Supported Radius Attributes - ZyXEL Communications GS1920v2 Series User Manual

The following table describes the VSAs supported on the Switch.
Table 97 Supported VSAs
FUNC T IO N
Ingress Bandwidth
Assignment
Egress Bandwidth
Assignment
Privilege Assignment
25.6.1.1 T unne l Pro to c o l Attrib ute
You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS server
documentation) to assign a port on the Switch to a VLAN based on IEEE 802.1x authentication. The port
VLAN settings are fixed and untagged. This will also set the port's VID. The following table describes the
values you need to configure. Note that the bolded values in the table are fixed values as defined in
RFC 3580.
Table 98 Supported Tunnel Protocol Attribute
FUNC T IO N
VLAN Assignment
25.6.2 Suppo rte d RADIUS Attrib ute s
Remote Authentication Dial-In User Service (RADIUS) attributes are data used to define specific
authentication elements in a user profile, which is stored on the RADIUS server. This appendix lists the
RADIUS attributes supported by the Switch.
Refer to RFC 2865 for more information about RADIUS attributes used for authentication.
This section lists the attributes used by authentication functions on the Switch. In cases where the
attribute has a specific format associated with it, the format is specified.
Chapter 25 AAA
AT T RIBUT E
Vendor-Id = 890
Vendor-Type = 1
Vendor-data = ingress rate (Kbps in decimal format)
Vendor-Id = 890
Vendor-Type = 2
Vendor-data = egress rate (Kbps in decimal format)
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
Vendor-ID = 9 (CISCO)
Vendor-Type = 1 (CISCO-AVPAIR)
Vendor-Data = "shell:priv-lvl=N"
where N is a privilege level (from 0 to 14).
Note: If you set the privilege level of a login account differently on the RADIUS
server(s) and the Switch, the user is assigned a privilege level from the
database (RADIUS or local) the Switch uses first for user authentication.
AT T RIBUT E
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
Note: You must also create a VLAN with the specified VID on the Switch.
GS1920v2 Series User's Guide
233
VLAN ID