ZyXEL Communications GS1920v2 Series User Manual page 74

Password Prompt
Fig ure 57
The following table describes the icons numbered from left to right in the ZON Utility screen.
Table 10 ZON Utility Icons
IC O N
1 IP configuration
2 Renew IP Address
3 Reboot Device
4 Reset Configuration to
Default
5 Locator LED
6 Web GUI
7 Firmware Upgrade
8 Change Password
9 Configure NCC
Discovery
10 ZAC
11 Clear and Rescan
12 Save Configuration
13 Settings
The following table describes the fields in the ZON Utility main screen.
Table 11 ZON Utility Fields
L ABEL
Type
Model
Firmware Version
Chapter 7 Status and ZON
DESC RIPT IO N
Change the selected device's IP address.
Update a DHCP-assigned dynamic IP address.
Use this icon to restart the selected device(s). This may be useful when troubleshooting
or upgrading new firmware.
Use this icon to reload the factory-default configuration file. This means that you will
lose all previous configurations.
Use this icon to locate the selected device by causing its
Use this to access the selected device web configurator from your browser. You will
need a username and password to log in.
Use this icon to upgrade new firmware to selected device(s) of the same model. Make
sure you have downloaded the firmware from the Zyxel website to your computer and
unzipped it in advance.
Use this icon to change the admin password of the selected device. You must know
the current admin password before changing to a new one.
You must have Internet access to use this feature. Use this icon to enable or disable
the Nebula Control Center (NCC) discovery feature on the selected device. If it's
enabled, the selected device will try to connect to the NCC. Once the selected
device is connected to and has registered in the NCC, it'll go into the Nebula cloud
management mode.
Use this icon to run the Zyxel AP Configurator of the selected AP.
Use this icon to clear the list and discover all devices on the connected network
again.
Use this icon to save configuration changes to permanent memory on a selected
device.
Use this icon to select a network adaptor for the computer on which the ZON utility is
installed, and the utility language.
DESC RIPT IO N
This field displays an icon of the kind of device discovered.
This field displays the model name of the discovered device.
This field displays the firmware version of the discovered device.
GS1920v2 Series User's Guide
74
LED to blink.
L o c a to r