Restore Configuration - ZyXEL Communications GS1920v2 Series User Manual

After the firmware upgrade process is complete, see the
firmware version number.
Table 165 Management > Maintenance > Firmware Upgrade
L ABEL
Name
Version
Current Boot Image
Config Boot Image
Apply
Cancel
Firmware
File Path
Upgrade
39.4 Re sto re C o nfig ura tio n
Use this screen to restore a previously saved configuration from your computer to the Switch.
Management > Maintenance > Restore Configuration
Fig ure 249
Type the path and file name of the configuration file you wish to restore in the
C ho o se File
configuration file on the Switch, so your backup configuration file is automatically renamed when you
restore using this screen.
Chapter 39 Maintenance
DESC RIPT IO N
This is the name of the Switch that you're configuring.
The Switch has two firmware sets,
• shows the version number (and model code) and MM/DD/YYYY creation date
Running
of the firmware currently in use on the Switch (
information is also displayed at System Information in Basic Settings.
• shows its version number (and model code) and MM/DD/YYYY creation
Firm wa re 1
date.
• shows its version number (and model code) and MM/DD/YYYY creation
Firm wa re 2
date.
This displays which firmware is currently in use on the Switch (
Select which firmware (
Switch to see changes, you will also see changes in the
well.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Choose to upload the new firmware to (Firmware)
Type the path and file name of the firmware file you wish to upload to the Switch in the
text box or click
Pa th
Click to load the new firmware. Firmware upgrades are only applied after a
Upg ra de
reboot. To reboot, go to
or
C o nfig 2 Fa c to ry De fa ult
files you want the Switch to use when it restarts).
to locate it. After you have specified the file, click
GS1920v2 Series User's Guide
Syste m Info
and
Firm wa re 1
or
Firm wa re 1 Firm wa re 2)
to locate it.
C ho o se File
Ma na g e m e nt > Ma inte na nc e > Re b o o t Syste m
( , and
C o nfig 1 C o nfig 2
Re sto re
343
screen to verify your current
, residing in flash.
Firm wa re 2
or . The firmware
Firm wa re 1 Firm wa re 2)
or
Firm wa re 1 Firm wa re 2)
should load, click and reboot the
Apply
field above as
C urre nt Bo o t Im a g e
link on the top navigation panel to
Sa ve
or (Firmware) .
1 2
and click
are the configuration
Fa c to ry De fa ult
text box or click
File Pa th
. "config" is the name of the
.
File
,
C o nfig 1